Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact.
Your Z-300 Fogger machine should be accompanied by the following items:
1. This user manual!
2. Power cord
3. ZC-6 multi-function remote control with attached cord
If any equipment is missing contact your Fogger dealer immediately.
Before beginning initial setup of your Z-300 Fogger, make sure that there is no evident damage caused by
transportation. In the event that the unit’s housing or cable is damaged, do not plug it in and do not attempt to use it
until after contacting your Z-300 Fogger dealer for assistance.
Setup
Remove all packing materials from shipping box. Check that all foam and plastic padding is removed.
Clean the spray nozzle to be sure the nozzle without any hindrance. Please contact with your vendor when you find
any destroy or omitting parts.
Place Fogger on a flat surface and remove liquid tank cap.
Pour high quality fog Liquid into the liquid tank, being careful not to exceed the maximum fluid level. DO NOT
OVERFILL. Use only our Fogger Liquid or other dealer-recommended high-quality Fog fluid. Any other types of
fluid can damage the unit. When the container is full ,place the cap back on the liquid tank and tighten.
Your Fogger can only be operated by connecting the ZC-6 remote control into the remote control slot in the back of
the machine
Operation
Plug the remote control cord into slot marked remote control on the back of the Fogger machine. Plug the power
cord into a grounded electrical outlet
Turn on the power switch located on the back of the Fogger machine
The red light on the remote control will turn on once the machine is plugged into a power outlet and the on/off
switch is turned on
Once the red light comes on the machine must warm-up .This period varies depending on conditions but should not
take more than 10 minutes under any circumstances
The green light on the remote control will turn on once the machine is ready to produce haze. When the green light
turns on, the machine may be operated using the remote control.
The Z-300 Fogger is controlled via the ZC-6 remote control. Please refer to the section titled Remote control
Operation for detailed instruction on the various functions available
Prior to the green light turning on the machine will not haze and the functions will not respond
When the Fogger does not have any liquid in the machine the PC board will shut off the pump so that the machine
will not be damaged. The pump will remain off until fluid is added to the machine
Please clean the machine not more than 40 hours into the mix cleaner consist of 80% pure water and 20% vinegar
as follows.
1. Before use, dismount and clean the nozzle with vinegar to ensure it without any remains.
2. Empty the tank, then pour clean liquid instead of fog liquid to spray until clean liquid runs off.
3. Assemble the nozzle and pour the fog liquid again for next operation.
Important:
Always monitor tank fluid level during operation. The Z-300 Fogger machine can suffer damage when run without
fluid. If the machine does not function after having been run without fluid please contact your Fogger dealer for service
If you experience low output mechanical noise or no output at all. Unplug immediately. Check fluid level, the external
(8 Seiten)
(1 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern